12
Note
Detailed information on the design of a MaxComm communication network
can be found in the technical details on MaxComm. This document can be
downloaded from our website (www.solarmax.com; area downloads/data
communication).
5�5 Power supply
The power supply to the data logger is supplied by the plug-in mains unit (included in the
delivery package).
WARNING!
Risk of re when unsuitable mains units are used!
For the power supply, you must use the plug-in mains unit included in the
delivery package.
Note
The power supply should be independent of the inverter AC feed cable. If
this is not the case, the MaxWeb xp will be disconnected from the power
supply when the inverters disconnect from the mains.
Use an uninterruptible 230 VAC power supply for the plug-in mains unit.
Any interruption in the mains power supply can lead to total failure of the
MaxWeb xp. In that case, the warranty becomes void and users cannot
make any claims under guarantee.
5�6 Changes in the MaxComm network
If you change the MaxComm network, e.g. by adding or replacing devices, you must rst
update the recorded data on the MaxWeb Portal.
ATTENTION!
Possible data loss!
The data logger is reset every time a device search is carried out. Update
the recorded data on the MaxWeb Portal before starting a device search.
To Next Page
Loading...