SolarMax MaxWeb xp - Portal Registration; Re-establishing GPRS Wiring; Activate External Display; Connect External Display

32
6�6 MaxWeb Portal registration
You need to register in order to obtain the access data for the MaxWeb Portal.
1. Open the MaxWeb xp user interface.
2. In the “Basic settings” menu, click on “General”.
3. Enter a valid email address in the “MaxWeb Portal” eld.
4. Click “OK”.
As soon as MaxWeb xp sends the rst data set to the MaxWeb Portal, you will receive your
acces data via email.
6�7 Re-establishing the wiring for MaxWeb xp GPRS
After completing the conguration of MaxWeb GPRS, remove the long red Ethernet cable
from the “Ethernet” socket and connect the “Modem” and “Ethernet” sockets of the
MaxWeb xp GPRS using the short red Ethernet cable (see wiring diagram in Section 5.2).
6�8 External displays
6�8�1 Activating MaxDisplay
To use MaxWeb xp for controlling an external display you rst have to activate the display
interface. Proceed as follows:
1. Open the menu item Devices/External devices.
2. Select “MaxDisplay 1.0” to use a display from another manufacturer. Select “Max
Display 2.0” to use MaxWeb xp in conjunction with the MaxVisio display.
3. Click “OK“ to save the changes. The display interface is now active.
6�8�2 Connecting the display
Connection conditions
RJ45 sockets (MaxWeb xp and inverter)
Procedure
Connect the display to a free RS485 connection of MaxWeb xp. You may also connect
the external display to an inverter if the inverter is connected to MaxWeb xp by means of
Ethernet (see Section 5.4). MaxWeb xp will detect the display automatically.