SolaX Power X1-EVC Series - Preparation before Installation; Selection of Installation Location

12
4 Preparation before Installation
4.1 Selection of Installation Location
The installation location selected for the EV-Charger is quite critical in the aspect of the
guarantee of device safety, service life and performance.
• It has the IP65 ingress protection, which allows it to be installed outdoor;
• The installation position shall be convenient for wiring connection, operation and
maintenance.
4.1.1 Environment Requirement
Make sure the installation site meets the following conditions:
• The ambient temperature: -30°C to +50°C (without screen),
-20°C to +50°C (with screen);
• The humidity shall be between 5-95%;
• Do not install the EV-Charger in the areas where the altitude exceeds 2000 m;
• Install the EV-Charger in a well-ventilated environment for heat dissipation;
• Do not install the EV-Charger in areas with flammable, explosive and corrosive
materials;
• Do not install the EV-Charger in areas near combustibles and antenna;
• You are recommended to install an awning over it. Direct sunlight, rain exposure
and snow laying up is not allowed.
-30°C-+50°C
(without screen)
-20°C-+50°C
(with screen)
No direct sunlight No rain exposure No snow lay up
Rain exposureNear combustibles Direct sunlight Snow lay up Near antenna
5-95%RH
IP65