36
7 Power on
7.1 Checking before Powering on
Check all below steps before powering on the EV-Charger:
a. Check that the device is installed correctly and securely;
b. The AC input cable is connected correctly and securely;
c. The communication cables are connected correctly and securely;
d. The voltage, frequency and other factors of the grid are in consistent with the
working requirement of the EV-Charger.
7.2 Powering on
Step 1: Turn on the RCBO.
Step 2: Check the status of the LED indicators: When the device is powered on, all
the LED indicators will be on for three seconds, then the system will start self-
checking automatically. After the checking process, the "AVAILABLE" light will be
on when the charging connector is not plugged and the "PREPARING" light will
be on when plugged.
If the "Fault" light is on, please check if it is correctly installed and connected.
WARNING!
• Power to the device must be turned on only after installation work has been
completed.
• The device is intended only for charging electric vehicles. Do not charge other
devices.
To Next Page
Loading...
Need help?
General
