49
9 Operation Method
9.1 States
The states of this series of EV-Charger are described as below:
Table 9-1 States
State Indicator Light & Description
Available
The "AVAILABLE" indicator light is on. The EV-Charger is powered on but
the charging connector is not plugged into the EV.
Preparing
The "PREPARING" indicator light is on. The EV-Charger is connected with
the EV but not charging.
Charging
The "CHARGING" indicator light is on or flashing. When the light is on,
the EV-Charger is charging normally; when it is flashing, the charging is
suspended due to some certain reason.
Finishing
The "COMPLETE" indicator light is on. The EV-Charger has completed
charging.
Unavailable
The "Unavailable" indicator light is on. The EV-Charger cannot charge even
if the charging connector is plugged in.
Network
The "Network" indicator light is on. The EV-Charger has been successfully
connected with network server.
Fault The "Fault" indicator light is on. The EV-Charger is in fault state.
Upgrade
The upper four operating status indicator lights will flash at the same time.
The EV-Charger is remote upgrading.
RFID card
Rewite
The upper four operating status indicator lights will light up in sequence
and cycle. The RFID card is being rewrote.
9.2 Start-up Patterns
The EV-Charger has three start-up patterns in total, namely plug & charge, card-swiping,
and APP activation pattern. There is a built-in electronic lock in Socket Type.
Home scene
In Home scene, all the three start-up patterns are available and the default pattern is plug
& charge. The Activation mode must be selected as RFID on the App if the card-swiping
pattern is to be used.
To Next Page
Loading...
