76
12 Decommissioning
12.1 Disassembling the EV-Charger
WARNING!
• When disassembling the EV-Charger, strictly follow the steps as below.
• Use insulated tools and wear individual protective tools when disassembling the
EV-Charger.
Step 1: Turn off the RCBO to disconnect the EV-Charger from the grid and/or inverter.
Step 2: Wait for at least 5 minutes to fully discharge the capacitors inside the EV-Charger.
Step 3: Remove the self-tapping screw on the right bottom of the EV-Charger.
Step 4: Take down the EV-Charger from the bracket.
Step 5: Remove the screws of rear cover and the base plate of communication board.
Then pull the base plate of communication board out.
Step 6: Disconnect the AC input cable.
Step 7: Disconnect the communication cable(s).
Step 8: Remove the bracket (and the cable hook) if necessary.
12.2 Packing the EV-Charger
• Load the EV-Charger into the original packing material if possible.
• If the original packing material is not available, you can also use the packing
material which meets the following requirements:
»
Suitable for the weight of product.
»
Easy to carry
»
Be capable of being closed completely
12.3 Disposing of the EV-Charger
Please dispose of the EV-Charger or its accessories in accordance with the disposal
regulations for electronic waste which is applied at the installation site.
To Next Page
Loading...
