23
Preparation before Installation
4.2 Tools Requirement
Installation tools include but are not limited to the following recommended ones. If
necessary, use other auxiliary tools on site.
Hammer drill MarkerMeasuring tape
Torque wrench Rubber mallet Heat gun
Ø12 mm Heat
shrink tubing
Anti-dust mask Safety gloves
Spirit levelWire stripper Hydraulic wire crimper
Safety goggles
Crimping tool for RJ45
Safety boots
4.3 Additionally Required Materials
The following is a recommended list of equipment required for installation of the battery
system.
Table 4-1 Additionally required wires
No. Required Material Type Diameter/ Conductor Cross-section
1 Protective pipe Corrugated pipe External diameter: over 60 mm
2 Grounding cable / 16 mm²
To Next Page
Loading...
