50
Wiring
Cable seal
ring Tail cover
Figure 7-11 Inserting the stripped wire
Step 3: With care, strip the cable jacket about 15±1 mm from the end.
15 ± 1 mm
Conductor
Cable jacket
Wire stripper
Figure 7-12 Striping cable jacket
NOTICE!
• DO NOT damage the conductor while sliding the jacket off the power cable end.
• The wire size of the power cable delivered with the accessories kit is 25 mm (3 AWG).
Step 4: Fit the connector body over the conductor strands, and squeeze the crimper to
crimp the terminal. The conductor strands exposed shall not be over 1 mm.
Plastic
housing
The exposed conductor < 1 mm
7±0.2 mm
Cross section
of joint part
Hydraulic wire crimper
Figure 7-13 Fitting connector body and crimping terminal
To Next Page
Loading...
