Solcon MPS 3000 User Manual

MESSAGES
Page 21 of 67
"O.K.".
Self Test Failed
Error Code = 32
Displayed as a response to finding an error
during the operation of Test procedure.
In case of test failure, reset and test again. If
problem persists then Error Code should be
reported to Authorized Factory representative.
CONSTANT MESSAGES
Constant messages are displayed upon a fault. Example:
TRIP:
MAX START TIME
Notes:
1. Pressing Store key while the LCD displays on "Data Page" or a "Set Page" parameter, will store this parameter
as the default display. If no key is pressed for more than five minutes, then this parameter becomes the default
display parameter
Constant messages are displayed, as a response to an event and not as a result of an operator action.
Display Description
Alarm:
U/C level 1
Displayed when the Alarm LED illuminates. The lower line displays the fault
name.
Trip:
U/C Level 2
Displayed when the Trip LED illuminates. The lower line displays the fault
name.

Solcon MPS 3000 Specifications

General

Brand	Solcon
Model	MPS 3000
Category	Power Supply
Language	English