SET PAGE - MENUS
Page 54 of 67
43. RTD 9 Level 2 ( - ) ( ) ( - ) ( ) ( - ) ( ) ( + ) ( ) ( + ) ( ) ( - ) ( ) ( - ) ( ) Always 49R
44. RTD 10 Level 1 ( - ) ( ) ( - ) ( ) ( - ) ( ) ( + ) ( ) ( + ) ( ) ( - ) ( ) ( - ) ( ) Always 49R
45. RTD 10 Level 2 ( - ) ( ) ( - ) ( ) ( - ) ( ) ( + ) ( ) ( + ) ( ) ( - ) ( ) ( - ) ( ) Always 49R
46. Under Pwr Level 1 ( - ) ( ) ( - ) ( ) ( - ) ( ) ( + ) ( ) ( + ) ( ) ( - ) ( ) ( - ) ( ) Run 32L
47. Under Pwr Level 2 ( - ) ( ) ( - ) ( ) ( - ) ( ) ( + ) ( ) ( + ) ( ) ( - ) ( ) ( - ) ( ) Run 32L
48. Low Power Factor ( - ) ( ) ( - ) ( ) ( - ) ( ) ( + ) ( ) ( + ) ( ) ( - ) ( ) ( - ) ( ) Run 55
49. Analog Input # 1 ( - ) ( ) ( - ) ( ) ( - ) ( ) ( + ) ( ) ( + ) ( ) ( - ) ( ) ( - ) ( ) Always ??
50. Analog Input # 2 ( - ) ( ) ( - ) ( ) ( - ) ( ) ( + ) ( ) ( + ) ( ) ( - ) ( ) ( - ) ( ) Always ??
51. Analog Input # 3 ( - ) ( ) ( - ) ( ) ( - ) ( ) ( + ) ( ) ( + ) ( ) ( - ) ( ) ( - ) ( ) Always ??
52. Analog Input # 4 ( - ) ( ) ( - ) ( ) ( - ) ( ) ( + ) ( ) ( + ) ( ) ( - ) ( ) ( - ) ( ) Always ??
Added options available in the MPS3000 which correspond to ANSI codes
Speed Switch Input (No Rotation detector) 14
Lock-Out on thermal Trip 86
RTD Bias for Thermal Overload ??
Unbalance Bias for Thermal Overload ??
Low Speed switch of Two-Speed motor ??
Emergency switch effect on Thermal Overload (reset of thermal capacity when stopped) ??
Emergency switch effect on Too Many Starts (not recording starts while in emergency) ??
Fault Simulation (of Voltages, currents, temperature)
??
To Next Page
Loading...
Need help?
General
