Plug-in Mixer Tutorial
121
SSL UF1 User Guide
Plug-in Mixer - Tutorial
The following tutorial guides you through configuring and using the Plug-in Mixer profile on UF1.
SSL 360° Setup
1. Open the SSL 360° application on your computer. Go to the HOME page and check that your UF1 has been detected by SSL
360°.
2. Go to the UF1 page and set a Layer to Plug-in Mixer using the drop-down list.
Plug-in Mixer Setup
UF1 follows selected Plug-in Mixer Channel Strip instance - With this setting enabled, UF1 will always follow the selected
360°-enabled channel strip instance, which effectively means UF1 and UC1's selected channels are linked together. Disabling
this setting, is the same as engaging the MASTER key on UF1 which means that UF1 can control a different 360°-enabled channel
strip to the one that UC1 is controlling.
Automatically page Soft Keys to follow last moved Channel Strip plug-in parameter - With this setting enabled, UF1 will
automatically page it's large display and V-Pots to the page of the last adjusted channel strip parameter - e.g. in response the
parameter being changed in the plug-in itself, the 360° Plug-in Mixer, or UF8/UC1. With this disabled, UF1's soft key page and
V-Pots assignment must be changed manually using the Page left and right keys beneath V-Pots 3 and 4. It is recommended to
leave this setting disabled if using UF1 and UC1 together, with the intention that you would leave UF1 set to Soft Key Page 1 of
8, as it hosts all the channel strip parameters that are in UC1's Extended Functions menu, therefore giving you easy access to all
the parameters across UF1 and UC1.
STEP 1 : Open SSL 360° application.
Check your UF1 has been detected.
STEP 2 : Select the Plug-in Mixer
prole from the UF1 page.
To Next Page
Loading...
Need help?
General
