Safety Notices
136
SSL UF1 User Guide
Safety Notices
General Safety
• Please read and keep this document and adhere to all warnings and instructions.
• This electrical equipment should not be exposed to dust, water, or other liquids.
• Clean only with dry cloth or products compatible with electrical devices and never when the unit is powered.
• Do not operate near any heat sources, in direct sunlight or near naked flames.
• Only use attachments/accessories recommended by the manufacturer.
• When using this equipment place it on a secure level surface.
• Do not block any ventilation openings and always allow free flow of air around the unit for cooling.
• Ensure that no strain is placed on any cables connected to this apparatus. Ensure that all such cables are not placed where
they can be stepped on, pulled or tripped over.
• Unplug this apparatus during lightning storms or when unused for long periods of time.
• Do not place heavy objects on the unit.
• Do NOT modify this unit, alterations may affect performance, safety and/or international compliance standards.
• SSL does not accept liability for damage caused by maintenance, repair or modification by unauthorised personnel.
Power Safety
• This equipment is supplied with a 100-240VAC, 12 V AC/DC power adapter with a changeable plug – please select the plug
suitable for your region.
• Only use cords and power adapters recommended by the manufacturer.
• Only connect units to single phase supplies with the neutral conductor at earth potential.
• Both the mains plug and appliance coupler can be used as the disconnect device, ensure that the mains plug is connected
to an unobstructed wall outlet and is permanently operable.
• Protect the adapter and power cord from being walked on or crushed.
CAUTION! No user-serviceable parts inside. In the event of damage to the unit or power supply contact
your Solid State Logic retailer. Service or repair must be done by qualified service personnel only.
(EN only)
UKCA
This product complies with the following United Kingdom Legislation:
UK Electrical Equipment (Safety) Regulations 2016 (SI 2016/1101)
UK Electromagnetic Compatibility Regulations 2016 (SI 2016/1091).
The Eco-design requirements for Energy related products (ErP) 2009/125/EC.
The Restriction of the use of certain Hazardous Substances in Electrical and Electronic Equipment
Directive (RoHS 2) 2011/65/EU.
To Next Page
Loading...
Need help?
General
