Safety Notices
137
SSL UF1 User Guide
EU
This product complies with the following European Union Harmonisation Legislation:
EU Low Voltage directive (LVD) 2014/35/EU,
EU Electromagnetic Compatibility directive (EMC) 2014/30/EU.
The Eco-design requirements for Energy related products (ErP) 2009/125/EC.
The Restriction of the use of certain Hazardous Substances in Electrical and Electronic Equipment Directive
(RoHS2) 2011/65/EU.
This product is CE compliant. Note that any cables supplied with SSL equipment may be fitted with ferrite rings at each end. This
is to comply with the current regulations and these ferrites should not be removed.
Electromagnetic Compatibility
EN 55032:2015, Class B. EN 55035:2017.
Electrical Safety
EN 62368-1:2014 + A11:2017.
(EN Only)
FCC Certication
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
For USA – to the user
Do not modify this unit! This product, when installed as indicated in the instructions contained in the installation manual, meets
FCC requirements.
Important: This product satisfies FCC regulations when high quality shielded cables are used to connect with other equipment.
Failure to use high quality shielded cables or to follow the installation instructions may cause electromagnetic interference with
appliances such as radios and televisions and will void your FCC authorisation to use this product in the USA.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Industry Canada Compliance
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. (EN, FR, ES only)
To Next Page
Loading...
Need help?
General
