User Manual
ā Use the original box to repackage the inverter, seal with adhesive tape with the desiccant
inside the box.
ā Store the inverter in a clean and dry place, free of dust and dirt. The storage temperature
must be between -40~158Ā°F and humidity should be between 0 to 100%, non-condensing.
ā Do not stack more than two (2) inverters high on a single pallet. Do not stack more than
2 pallets high.
ā Keep the box(es) away from corrosive materials to avoid damage to the inverter enclosure.
ā Inspect the packaging regularly. If packing is damaged (wet, pest damages, etc.), repackage
the inverter immediately.
ā Store inverters on a flat, hard surface -- not inclined or upside down.
ā After 100 days of storage, the inverter and carton must be inspected for physical damage
before installing. If stored for more than 1 year, the inverter needs to be fully examined and
tested by qualified service or electrical personnel before using.
ā Restarting after a long period of non-use requires the equipment be inspected and, in some
cases, the removal of oxidation and dust that has settled inside the equipment will be required.
1.7 Storage
If the inverter is not installed immediately, storage instructions and environmental conditions are listed below:
DO NOT STACK
MORE THAN HIGH
2
1. Introduction
SAVE THESE INSTRUCTIONS ā This manual contains important instructions for Models
S6-GC25K-US, S6-GC33K-US, S6-GC36K-US, S6-GC40K-US, S6-GC50K-US, S6-GC60K-US
S6-GC30K-LV-US that shall be followed during installation and maintenance of the inverter.
5
1.8 Notice for Disposal
This product shall not be disposed of with household waste. They should
be segregated and brought to an appropriate collection point to enable
recycling and avoid potential impacts on the environment and human health.
Local rules in waste management shall be respected .
To Next Page
Loading...
Need help?
General