Important Safety Instructions
In these safety instructions the word “product” refers to SOLOSHOT2 including the BASE, TAG and all of it’s accessories.
1. Read Instructions - All safety and operating instructions should be read completely and understood completely before the product is operated.
2. Retain Instructions - These safety and operating instructions should be retained for future reference. The operator of this equipment should, from time to time, review the manufacturers website for any new or
revised instructions, warnings and safety information.
3. Heed Warnings - All warnings on the product and in the operating instructions should be read, understood and adhered to.
4. Follow all instructions.
5. Do not expose BASE directly to water.
6. Do not place any part of SOLOSHOT2 near any heat sources such as radiators, heat registers, ovens, stoves, or other apparatus (including amplifiers) that produce heat.
7. Only use attachments and accessories specified or approved by the manufacturer of SOLOSHOT2.
8. Unplug this apparatus during lightning storms or when unused for long periods of time.
9. Refer all servicing to qualified service personnel approved by the manufacturer. Servicing is required when the apparatus has been damaged in any way, including power-supply cord or plug damage, liquids have
been spilled into or around the BASE or CHARGER or objects have fallen into the apparatus, the BASE or CHARGER has been exposed to rain or moisture, does not operate normally, or has been dropped.
10. Follow Instructions - All operating and maintenance instructions should be followed.
11. Cleaning – Clean BASE and TAG separately. Clean BASE only with a dry cloth. Unplug BASE from the wall outlet and completely detach CHARGER from BASE before cleaning. Only use a clean dry cloth to clean
the external surfaces of BASE. Do no use liquid or aerosol cleaners on BASE. Clean the TAG only by rinsing in fresh water. The product should be cleaned only as recommended in this manual.
12. Accessories - Only use accessories recommended in this manual as all other accessories may be hazardous.
13. Avoid magnetic or electric fields - Do not use SOLOSHOT2 close to TV transmitters, portable communication devices or other sources of electric or magnetic radiation. They may cause interference or permanent
damage to your SOLOSHOT2.
14. Water and moisture - ELECTRIC SHOCK HAZARD - Do not expose BASE or CHARGER to wet environments. The TAG is waterproof up to 10 ft but BASE and CHARGER are NOT waterproof or water resistant.
15. The TYP60-0901500u Compact Power Adapter (CHARGER) should be operated only from the type of power source indicated on the marking label (AC100 to 240V). If you are not sure of the power supply in your
home, consult your local power company. ONLY USE CHARGER AS DESCRIBED IN THIS INSTRUCTION MANUAL.
16. Power Cord Protection - The power cord of the CHARGER should be routed such that it is NOT likely to be walked on or pinched by items placed upon or against it. Pay particular attention to plugs and the point
from which the cords exit the product.
17. Objects and Liquid Entry - Never push objects of any kind into or through openings of BASE or TAG as they may touch dangerous voltage points or short-out parts that could result in fire or electric shock or
damage to product. Be careful not to spill liquids of any kind on BASE or CHARGER.
18. Servicing - Do not attempt to service any part of SOLOSHOT2 yourself as opening or removing covers or otherwise removing or altering any component of SOLOSHOT2 may expose you to dangerous voltage or
other hazards. Refer all servicing to qualified service personnel. Any attempt to access internal components will void manufacturers warranty.
19. Rinse TAG, CLIP and ARMBAND in fresh water after use in salt water.
To Next Page
Loading...
