Set Up Each Base Using the Same Tag and Standard Calibration
Use the same Tag to calibrate each Base using the steps described in the Cheat Sheet of this Manual.
Each Base you calibrate will be in Single Mode by default (LED4 = GREEN) and will be tracking the Tag used to
calibrate it. If you want each Base to track multiple Tags, you must set each Base to Multi Mode (LED4 = RED ) and pair
the desired Tags to the System as described on page 27 - 29.
ADDING BASES - METHOD 1
TIP – You can adjust the settings on each Base individually to suit your needs. For example, you can set
your first base to Surf & Turf Mode +Jump Detection while setting your second Base to Big Altitude
Mode + Standard Tracking. Alternatively, you can have all the Bases set to the same Mode but use
different zoom settings so that you have plenty of shots to choose from during editing.
43
MULTI SYSTEMS
To Next Page
Loading...
