Sony BVM-14F5U - Page 31

27
220 PROBE (STD/COL1/COL2/xxCH): Select the probe for color temperature adjustment.
SONY BKM-14L...: Use the BKM-14L. ÷ 230
GRASEBY SLS 9400...: Use the SLS 9400. ÷ 241
MINOLTA CA-100...: Use the CA-100. ÷ 241
PHILIPS PM 5639...: Use the PM 5639. ÷ 241
THOMA TF6...: Use the TF6. ÷ 241
• If you cannot execute an ADJUST or ANALYZE menu operation when using the Sony
BKM-14L probe, try again after disconnecting and reconnecting the probe.
• When using the Thoma TF6 probe, set the TF6 PRINT menu to off.
241 PROBE (STD/COL1/COL2/xxCH): Select the probe. Select either D65 or D93, and enter
values for LOWLIGHT and HIGHLIGHT. Rather than selecting D65 or D93, you may instead
enter the values of the CIE 1931 color system x and y coordinates.
D65: Use D65.
D93: Use D93.
X: Enter the x coordinate.
Y: Enter the y coordinate.
LOW LIGHT (20IRE): Enter the brightness (cd/m
2
) for low light.
HIGH LIGHT (100IRE): Enter the brightness (cd/m
2
) for high light.
START: Start adjustment. ÷ 242
242 COLOR TEMP ADJ (STD/COL1/COL2/xxCH): Perform adjustment.
SET PROBE ON CRT
PRESS ENTER
Adjustment starts when the probe is placed against the center of the screen and the
ENTER button is pressed.
260 COPY (STD/COL1/COL2/xxCH): Select the source to be copied from.
OTHER VALUE...: Copy data from another channel or from common data. ÷ 261
OTHER MONITOR...: Copy data from another monitor. ÷ 263
MEMORY CARD...: Copy data from a memory card. ÷ 266
261 OTHER VALUE (STD/COL1/COL2/xxCH): Select STD, COL1,COL2, or CH
SET. ÷ Copy is carried out.
STD: Copy common data (factory setting: D65).
COL1: Copy common data (factory setting: D65).
COL2: Copy common data (factory setting: D93).
CH SET:Copy data from a particular channel (factory setting: D65). Enter the number of
the channel from which the data will be copied.
When the input channel number is deleted with the Del button. the number “1” appears
instead. Restore the previous setting by pressing the MENU button, then re-enter the
channel number. (Setting with the UP/DOWN buttons or PHASE knob is possible
without pressing the MENU button.)
D65: Copy the color temperature of D65.
D93: Copy the color temperature of D93.