Sony HCD-CP2 - Test Mode; MC Cold Reset

11
[MC Cold Reset]
• The cold reset clears all data including preset data stored in the
RAM to initial conditions. Execute this mode when returning
the set to the customer.
Procedure:
1. While pressing the ?/1 button, connect the power cord.
2. The set is reset.
[CD Aging Mode]
This mode can be used for operation check of CD section.
Procedure:
1. Load a CD disc.
2. Set to standby state.
3. Press three buttons of x (TAPE B), x (CD), and [TUNER]
simultaneously.
4. The aging is executed in bellow sequence.
5. To release from the aging mode, press the ?/1 button to turn
the power OFF.
Aging mode sequence:
[Tape Deck Aging Mode]
This mode can be used for operation check of tape deck section.
Procedure:
1. Set a tape in the tape deck-B.
2. Set to standby state.
3. Press three buttons of x (TAPE B), x (CD), and [TAPE]
simultaneously.
4. The aging is executed in bellow sequence.
5. To release from the aging mode, press the ?/1 button to turn
the power OFF.
SECTION 4
TEST MODE
Start
Open the disc tray
Close the disc tray
Play the last track
Aging mode sequence:
[Liquid Crystal Display All Lit Check Mode]
Procedure:
1. Set to standby state.
2. Press three buttons of
x (TAPE B), x (CD), and [VIDEO]
simultaneously.
3. Liquid crystal display are all turned on.
4. To release from this mode, press the ?/1 button to turn the
power OFF.
[ROM Version Display Mode]
Procedure:
1. Set to standby state.
2. Press three buttons of x (TAPE B), x (CD), and [DSG] si-
multaneously.
3. The ROM version is displayed.
Start
REC pause for 3 seconds
FWD REC
Fast forward
REV Play
REC pause for 3 seconds
REV REC
Rewind
FWD Play
Shut off
Shut off
Shut off
Shut off
1 minute
3 minutes
1 minute
3 minutes