3-9. Optical Connector Assembly
3-9-1. Neutrik Model
Preparation
1. Remove the cover. (Refer to “3-2. Cover”.)
Procedure
1. Disconnect the harness and cables.
(1) Open the clampers (1) to (4).
(2) Disconnect the harness from the connector (CN004) on the PS-934 board.
(3) Disconnect the two optical fiber cables from the AT-196 board.
Optical fiber cables
t
For the connection of the
optical fiber cables, refer to the
indication on the AT-196 board.
AT-196 board
AT-196 board
PS-934 board
Clamper (1)
Clamper (1)
Clamper (4)
[ 2 ]
Neutrik connector
[ 1 ]
Clamper (3)
CN004
Optical connector
No CN
12
Neutrlk
2 1 LEMO
HXCU-FB80
3-11
To Next Page
Loading...
Need help?
General
