2. Insert the Memory Stick that contains the upgrading program into the Memory Stick slot on the rear panel.
Memory stick slot
Memory stick
3. Select VERSION UP EXEC from MAIN on the M02: Firmware Update page of the MAINTENANCE menu.
4. A message “UPDATE MAIN BLOCK ?” appears. Turn the CANCEL/ENTER lever to the ENTER side.
DISP/MENU lever
CANCEL/ENTER lever
CONTROL knob
(Rotary encoder)
5. Check that “LOADER BLOCK COMPLETE!!“ appears and then “MAIN BLOCK COMPLETE!!” appears.
6. Turn off the power and remove the Memory Stick.
7. When the unit is turned on, the main program is upgraded and runs.
8. Check that the main program has been upgraded with “ROM Version” of status display. (Refer to the Operating
Instructions.)
5-1-2. Updating the BOOT Program
Equipment required
• Memory Stick
Check
Check the current boot program version with Firmware Update of the MAINTENANCE menu. (Refer to Section 6-3.)
HXCU-FB80
5-2
To Next Page
Loading...
Need help?
General
