Preparation
1. Copy the upgrading program to the Memory Stick in the following steps.
Note
To get the upgrading program (program files “HXCUFB80.rom” and “HXCUFB80_BOOT.rom”), contact your
local Sony Sales Office/Service Center.
(1) Make the following directory on the Memory Stick.
¥MSSONY¥PRO¥CAMERA¥HXCUFB80
(2) Copy the program files “HXCUFB80.rom” and “HXCUFB80_BOOT.rom” to the directory made in step 1.
Procedure
1. Turn on the power.
2. Insert the Memory Stick that contains the upgrading program into the Memory Stick slot on the rear panel.
3. Select VERSION UP EXEC from BOOT on the M02: Firmware Update page of the MAINTENANCE menu.
4. A message “UPDATE BOOT BLOCK ?” appears. Turn the CANCEL/ENTER lever to the ENTER side.
5. Check that version update is performed and a message “BOOT BLOCK COMPLETE!!” appears.
6. Turn off the power and remove the Memory Stick.
7. When the unit is turned on, the boot program is upgraded and runs.
8. Check that the boot program has been upgraded with Firmware Update of the MAINTENANCE menu. (Refer to
Section 6-3.)
HXCU-FB80
5-3
To Next Page
Loading...
Need help?
General
