Sony RM-PJ25 - Software Upgrade Method

2-7 (E)
VPL-HW40ES
2-6. Software Upgrade Method
2-6-1. Preparation
Required Equipment/Tools
. Personal computer (PC): RS-232C interface equipped
. RS-232C cross cable
. Main Flash upgrader for Sony Projector (for SUB CPU)
. Pixelworks FlashUpgrader (for scan converter)
. 3DGamma QuickAccess
(for 3DGamma/LookUpTable/DDC/NVM/ABGamma/LCK/OGMData/CSMatrixTable)
File configuration :
Executable: QuickAccess.exe
Readme File: readme_j.txt (Japanese)
readme_e.txt (English)
n
For obtaining the each application for upgrading and upgrade file, contact your local Sony Sales Office/
Service Center.
Preparation
1. Set Standby Mode to “Standard” on the Setup menu.
n
When the Standby Mode is not set to standard, the upgrade is failed.
2. Disconnect the power cord of this unit.
3. Connect PC to the REMOTE terminal on the connector panel of this unit using the RS-232C cross
cable.