71
Initial value and preset
• The initial values are the factory settings.
• When the power is turned on, this unit starts operation with the settings stored in preset 1.
• In “Preset 1 to 256”, the items that are preserved even after the power from the camera is turned off are indicated by a
circle (a), and the items that are not preserved are indicated by a cross (×).
• When turning the power off and on again, if you want to reflect the camera conditions and pan/tilt position that are set
before the power is turned off, store the settings in POSITION1.
• The setting or deleting of memory to/from preset 1 takes approx. 2 seconds longer than other channels.
• When ImageFlip is executed, all presets are reset to the initial value.
• CAM_Memory command is effective only for PRESET 1 through 16.
Mode/Position setting Initial settings Preset 1 Presets 2 to 256
Pan/Tilt Position Home position aa
Pan/Tilt Limit Position Maximum range of movement a ×
Zoom Position Wide end aa
D-Zoom On/Off On aa
Focus Position — aa
Focus Auto/Manual Auto aa
Near Limit settings D000h (30 cm) a ×
AF Sensitivity Normal a ×
AF Mode Normal a ×
AF Run Time 5 sec a ×
AF Interval 5 sec a ×
WB Mode Auto aa
WB Data (Rgain, Bgain) — aa
One Push WB Data — a ×
AE Mode Full Auto aa
WD Mode Off aa
Auto Slow Shutter Mode Off aa
Shutter Position — aa
Iris Position — aa
Gain Position — aa
Bright Position — aa
Exposure Compensation On/Off Off aa
Exposure Compensation Amount ±0 aa
BackLight On/Off Off aa
Aperture Level 0Ah aa
High Resolution Mode On/Off Off a ×
Picture Effect Off a ×
ICR On/Off Off aa
Auto ICR On/Off Off a ×
Auto ICR Threshold Level 0Eh a ×
Image Stabilizer On/Off Off a ×
High Sensitivity Mode On/Off Off a ×
Gamma 0:standard a ×
Defog On/Off Off aa
NR level 3 a ×
Gain Limit — a ×
Low-Illumination Chroma Suppress 2h (Middle) a ×
Color Gain 4h (100%) a ×
Color Hue 7h (0 degree) a ×
Notes
To Next Page
Loading...
