D-VIDEO BOARD IC3901 F2602E-01-TR (XM RECEIVER)
Pin No.
SCTXOUT O Serial data output to the system controller
VDD - Power supply terminal (+3.3V)
SCRXIN I Serial data input from the system controller
COMMSEL I Command mode selection signal input terminal Not used
VDD - Power supply terminal (+3.3V)
IRQ O Interrupt request signal output terminal Not used
RESET I Reset signal input from the system controller "L": reset
SLAVESL I
Master/slave mode setting terminal "L": master mode, "H": slave mode
Fixed at "L" in this set
VDD - Power supply terminal (+3.3V)
COMRXP I XM receiver differential signal (positive) input terminal
COMRXM I XM receiver differential signal (negative) input terminal
VDD - Power supply terminal (+3.3V)
COMTXM O XM transmitter differential signal (negative) output terminal
COMTXP O XM transmitter differential signal (positive) output terminal
OSCOUT O System clock output terminal (45.1584 MHz)
VDD - Power supply terminal (+3.3V)
OSCIN I System clock input terminal (45.1584 MHz)
VDD - Power supply terminal (+3.3V)
I2SDATA O I2S digital audio data output to the D/A converter, DSP1 and DSP2
I2SSCLK O I2S bit clock signal output to the D/A converter, DSP1 and DSP2
VDD - Power supply terminal (+3.3V)
I2SLRCLK O I2S L/R sampling clock signal output to the D/A converter, DSP1 and DSP2
I2SOCLK O I2S over sample clock signal output to the D/A converter, DSP1 and DSP2
VDD - Power supply terminal (+3.3V)