3 Advanced use
18 SOREDEX 208396 rev 2
1. Place two size 3 imaging plates into their correspond-
ing protective covers.
2. Slide the two size 3 imaging plates and protective cov-
ers into the Comfort Occlusal™ 4C bite protector.
3. Insert the Comfort Occlusal™ 4C bite protector and im-
aging plates into the Comfort Occlusal™ 4C hygiene
bag.
4. Seal the bag. Place the sealed Comfort Occlusal™ 4C
hygiene bag into the patient’s mouth and take an expo-
sure.
5. Remove the sealed Comfort Occlusal™ 4C hygiene
bag from the patient’s mouth. Open it.
6. Remove each individual imaging plate from the Com-
fort Occlusal™ 4C bite protector and process one at a
time.
7. Comfort Occlusal™ 4C image appear on the imaging
application software.
Note! When you are in the Occlusal 4C mode it is possible
to temporarily override the mode and process a single size
3 imaging plate. Insert the size 3 imaging plate into the unit
so that it can be processed. When the insert second plate
symbol appears on the unit user interface press the start
key. This cancels the Occlusal 4C mode for this operation
and produce a single size 3 image.
Size 3 image mode from each size 3 plate allows size 3 im-
aging plates to process as individual imaging plates.
Note! Due to Comfort Occlusal™ 4C projection imaging ge-
ometry and imaging plate positioning, accurate distance
and angle measurements cannot be taken from Comfort
Occlusal™ 4C projection images.
3.6 Full Mouth Series (FMS) imaging
For US only. To fully support FMS template feature in
imaging application SW magnetic FMS template for 18
imaging plates is available (PN0202398).
To Next Page
Loading...
