Soredex DIGORA Optime - Imaging Plate Wearing

7 Troubleshooting
208396 rev 2 SOREDEX 43
7.1.3 Imaging plate wearing
White or grey dots, spots or stains in images
■ Dust or stains on the imaging plates.
■ Any extra particle on top of the active sensitive
surface of the plate is visible on the image.
- Clean the plate(s).
- Replace if cleaning does not help.
- Pay attention on handling, storing and
maintenance. Ensure that only the genuine hy-
giene accessories are used.
Wearing of the imaging plate
Scratches
- Clean the plate(s).
- Replace if cleaning does not help.
- Pay attention on handling, storing and
maintenance. Ensure that only the genuine hy-
giene accessories are used.
Spots, dots (white or gray) or any visible pattern.
■ Most probably caused by wearing of the imaging
plate.
■ Can be caused by moisture or improper cleaning.
- Clean the plate(s), ONLY >70% ETHANOL
MUST BE USED.
- Replace if cleaning does not help.
- Pay attention on handling, storing and
maintenance. Ensure that only the genuine hy-
giene accessories are used.