DPU/DO - Page 21 - REV. 5/25/00
Safety Floor Monitor Diagnostic Screens
The display for a safety floor monitor will be quite different from these displays, mainly by
showing all the inputs of the sixteen possible floors instead of some of the other carriage
controller inputs. A typical floor monitor display is shown below.
--------------------------------
Unit Number -------------- 4
Unit Type - Floor Monitor
Revision - 1.3
Master Stop - Closed
On/Off/Override - 000
Jumpers JP8 - 01
<DOWN> <NEXT> <LAST>
-----Press <ESCAPE> to Exit-----
--------------------------------
-- Floor Monitor Inputs Screen #1 --
This screen reports general information on the unit being addressed. This information includes
the unit number of the control which is being addressed as well as the unit type, the revision
number of the internal software, the state of the master stop loop, the status of the key inputs and
the status of the two jumpers on the board. The next three screens show the status of the
individual floor inputs on the safety floor monitor board. Press the "DOWN" key to display the
next screen.
--------------------------------
Floor 1 - Closed 4
Floor 2 - Closed
Floor 3 - Closed
Floor 4 - Closed
Floor 5 - Closed
Floor 6 - Closed
<UP> <DOWN> <NEXT> <LAST>
-----Press <ESCAPE> to Exit-----
--------------------------------
-- Floor Monitor Inputs Screen #2 --
These inputs will read "Closed" if the floor is good, "Open" if the floor is being activated. Press
the "UP" key to return to the previous screen. Press the "DOWN" key to display the next screen.
Pressing the "ESCAPE" key returns to the Diagnostic Selection screen.
To Next Page
Loading...
Need help?
General
