DPU/DO - Page 45 - REV. 5/25/00
POWER PRO PARAMETER SCREENS
--------------------------------
**Set Parameters For Unit - 1 **
---> RESET MODE
(0) Automatic
*(1) Manual
Use < > to Select Option
Use <NUMBER> to Set Option
<SAVE> to Save <ESCAPE> to Exit
--------------------------------
-- Reset Mode Parameter Screen --
When in AUTOMATIC mode, the system will return to the Ready for Use (all green) display after
moving. If the MANUAL option is selected, the system will remain "locked" on the last aisle
accessed, with the Aisle in Use display on and the red LED flashing. In order to select a different
aisle the user must first press the reset button at the "locked" aisle changing the system to the
Ready for Use state. On the diagnostic keypad, press the LAST key to display the previous screen.
Press the NEXT key to display the next screen. If this screen is set for "Automatic,” the next two
screens will not be displayed.
--------------------------------
**Set Parameters For Unit - 1 **
---> AISLE RELOCK TIMER
*(0) No Relock
(1) Relock
Use < > to Select Option
Use <NUMBER> to Set Option
<SAVE> to Save <ESCAPE> to Exit
--------------------------------
-- Relock Aisle Parameter Screen --
This screen is only shown if manual reset mode has been selected. This feature permits a cleared
aisle to be locked again if the user does not select another aisle within the specified time. When
set for “No Relock” the system remains accessible until an entry sensor, sweep or move button is
activated. If this screen is set for "No Relock," the next screen will not be displayed.
To Next Page
Loading...
Need help?
General
