DPU/DO - Page 37 - REV. 5/25/00
--------------------------------
**Set Parameters For Unit - 1 **
--> ZFS PARAM 5
Enter Value <0-255> - 0_
Use < > to Select Option
Value <ENTER> to Set Option
<SAVE> to Save <ESCAPE> to Exit
--------------------------------
-- ZFS Parameter 5 Screen --
This screen is only shown if ZFS has been selected. This option is not used at this time.
--------------------------------
**Set Parameters For Unit - 1 **
---> ZFS SYSTEM ACCESS FOR QUADS
(0) Neither (2) Rear
*(1) Front (3) Both
Use < > to Select Option
Use <NUMBER> to Set Option
<SAVE> to Save <ESCAPE> to Exit
--------------------------------
-- ZFS Quadrature Usage Parameter Screen --
This screen is only shown if ZFS has been selected. This option allows for configuring dual and
single entry systems with the possibility of supporting no-quad systems.
--------------------------------
**Set Parameters For Unit - 1 **
---> ZFS ACTIVE AISLES
*(0) Right Only
(1) Both
Use < > to Select Option
Use <NUMBER> to Set Option
<SAVE> to Save <ESCAPE> to Exit
--------------------------------
-- ZFS Aisle Usage Parameter Screen --
This screen is only shown if ZFS has been selected. If the carriage is a master configured with
left aisle ZFS then select "Both." If the carriage is a slave configuration with right aisle ZFS then
select "Right Only."
To Next Page
Loading...