DPU/DO - Page 48 - REV. 5/25/00
POWER PRO PARAMETER SCREENS
--------------------------------
**Set Parameters For Unit - 1 **
--> LIGHTING TIMEOUT (seconds)
Enter Value <5-255> - 10_
Use < > to Select Option
Value <ENTER> to Set Option
<SAVE> to Save <ESCAPE> to Exit
--------------------------------
-- Lighting Timeout Parameter Screen --
This screen is only displayed if timed lighting has been selected. When equipped with bay
lighting every controller has to set for the desired timeout. This value can be set from 1 to 255
seconds or minutes depending upon units selected on previous page. See page 23 for details
regarding entry of a numeric value.
--------------------------------
**Set Parameters For Unit - 1 **
---> CONTROL HEAD BEEP OPTION
*(0) Beep
(1) Don’t Beep
Use < > to Select Option
Use <NUMBER> to Set Option
<SAVE> to Save <ESCAPE> to Exit
--------------------------------
-- Control Head Beep Disable Parameter Screen --
This parameter screen allows the user to disable the control head activation beep (either the reset
button or a valid move request). However, the override beep still sounds when the override key
is used with an activated sweep.
To Next Page
Loading...
Need help?
General
