DPU/DO - Page 52 - REV. 5/25/00
How To Save Parameters
When all parameter values are satisfactory, there are two methods to exit from the parameter set
screens.
•
Pressing the SAVE key will send the new values to the Power Pro/EC300A/EC400 controller
which is addressed (displayed in upper right hand corner), and cause those new parameters to
be permanent. One of two messages will be displayed depending upon the results of the save
request. Either the message "Saved and Verified" or "Save Failed!" will be displayed.
Pressing the ESCAPE key will exit the screen.
•
Or pressing the ESCAPE key just leaves this portion of the diagnostic unit and allows the
user to select another carriage controller or safety floor monitor. NO information will be
saved!
To Next Page
Loading...
Need help?
General
