DPU/DO - Page 24 - REV. 5/25/00
EC300A/EC400 PARAMETER SCREENS
-------------------------------
-
**Set Parameters For Unit - 1 **
---> MOVEMENT MODE
(0) Touch and Hold
*(1) One Touch
Use < > to Select Option
Use <NUMBER> to Set Option
<SAVE> to Save <ESCAPE> to Exit
--------------------------------
-- Movement Mode Parameter Screen --
The first of these screens deals with the movement mode of the mobile storage system. There are
two choices for this parameter. The first, TOUCH AND HOLD, requires the operator to
continue holding the move button on the face panel control until the movement is complete. The
second, ONE TOUCH, allows the operator to release the move button on the face panel control
and have the module complete the movement cycle on its own. Press the ESCAPE key to return
to the Diagnostic Selection screen. Press the NEXT key to display the next screen shown below.
--------------------------------
**Set Parameters For Unit - 1 **
---> RESET MODE
(0) Automatic
*(1) Manual
Use < > to Select Option
Use <NUMBER> to Set Option
<SAVE> to Save <ESCAPE> to Exit
--------------------------------
-- Reset Mode Parameter Screen --
This parameter allows the user to set the type of reset mode the system uses. If AUTOMATIC is
selected, the system will return to the Ready For Use display ("all green state" for an EC300/A)
immediately after successfully completing a movement cycle. If the MANUAL option is
selected, the system will remain "locked" on the last aisle accessed, with the Check Aisle - Press
Reset display (or a red arrow for EC300/A) indication showing the last selected aisle. In order to
select a different aisle the user must first press the reset button on the face panel control at the
"locked" aisle. Then, after the system has returned to Ready For Use (all green for an EC300/A),
a different aisle may be accessed. Press the LAST key to display the previous screen shown at
the top of this page. Press the NEXT key to display the next screen shown on the next page.
To Next Page
Loading...
Need help?
General
