SC5 Signal Conversion Index
iii
Contents
Conventions 6
Safety information 7
About this Manual 9
Introduction 10
Instrument Overview 11
Block diagram .................................................................................................................... 11
Front panel ......................................................................................................................... 12
Rear panel .......................................................................................................................... 13
Installation Guide 14
Content of delivery ............................................................................................................ 14
Setup .................................................................................................................................. 15
Connection to RC5 ............................................................................................................. 15
Electrical ground ................................................................................................................ 17
Powering ............................................................................................................................ 18
Analog Inputs 19
Analog inputs connection................................................................................................... 19
Analog inputs schematic .................................................................................................... 23
Inputs calibration procedure............................................................................................... 23
Specifications (inputs) ....................................................................................................... 24
Analog Outputs 25
Analog outputs connection................................................................................................. 25
Analog outputs schematic .................................................................................................. 28
Bipolar and unipolar operation .......................................................................................... 28
hrDAC™ ............................................................................................................................ 31
Introduction ......................................................................................................... 31
Calibration procedure .......................................................................................... 32
Specifications (outputs) ..................................................................................................... 33
Fast Analog Output 34
Fast analog output connection ............................................................................................ 34
Fast analog output schematic ............................................................................................. 34
Specifications (fast output) ................................................................................................ 35
Auxiliary Power Supply 36
Connection ......................................................................................................................... 36
Connection using Y-splitter ............................................................................................... 37
Schematic and connector pin layout .................................................................................. 37
Specifications (auxiliary power supply) ............................................................................. 38
Troubleshooting 39
Instrument doesn’t power up correctly .............................................................................. 39
Auxiliary power supply doesn’t work correctly ................................................................. 39
To Next Page
Loading...