32 SPEKTRUM NX7e • TRANSMITTER INSTRUCTION MANUAL
EN
Analog Switch Setup
Allows all sticks and pots to be used as a kick point to turn on
functions like mixes.
To add a kick point:
1. Move the control stick, lever or knob to the desired kick point
position.
2. Scroll to the desired kick point and press the scroll wheel once
to save the selection.
To delete a kick point, scroll to the desired kick point and press the
Clear button.
Digital Switch Setup allows you to define the position values of each
digital switch and flight mode switch. The switch can be assigned to
a channel in the Channel Input Config function, and the output of the
channel set in the Digital Input Setup screen. Additionally, the flight
mode switch can have position values defined for each flight mode,
and may be used as a mix input or channel input source, with the
values defined in Digital Input Setup.
To use the Digital Switch Setup function:
1. Enter the Digital Input Setup screen, and press the roller with
Inhibit selected.
2. Roll to select the switch or Flight Mode switch and press to
select.
3. Roll to the desired position to adjust, and press the roller to
select.
4. Roll to select the desired value, then press to select.
5. Repeat step 4 and 5 for all positions that you wish to adjust.
6. If you want to select a switch to control a channel, roll to
select Channel: Inhibit on the bottom of the screen and press
the roller. This will take you to the Channel Input Config screen
to assign a channel to a switch.
7. Repeat 2 through 6 for all switches desired.
IMPORTANT: After you exit the Digital Input Setup screen, the
return screen will show Inhibit at the top of the screen. If you wish
to adjust a previously set value, select the switch and the previously
set values can then be viewed and re-adjusted as desired.
Digital Switch Setup
To Next Page
Loading...
Need help?
General
