35SPEKTRUM NX7e • TRANSMITTER INSTRUCTION MANUAL
EN
The NX7e Timer function allows you to program a countdown timer
or stop watch (count up timer) to display on the main screen. An
alarm sounds when the programmed time is reached. You can
program the timer to start using the assigned switch position or
automatically when throttle is raised above a programmed position.
Two internal timers are available that show run time for a specific
model displays on the Main Screen. A total system timer is also
available.
Timer
Telemetry is in both the system setup and the function list so you
can access the telemetry functions from either list.
You must power off the receiver and transmitter, then power them
both on to reset the telemetry data. You can reset min/max values
by pressing the CLEAR button.
CAUTION: NEVER change Telemetry settings when the
aircraft is powered on. There is a brief interruption in RF
output when exiting the Telemetry screen, and may cause a
“Hold” condition.
Telemetry
If you Bind a Forward Programming capable receiver to your
NX7e, a Forward Programming menu will appear in the Function
List automatically. Think of the Forward Programming menu as
a programming interface for your connected receiver. The menu
structure, options and any changes made are done directly on
the receiver, the transmitter is only an interface. Each device may
have different menu structure and operate in a different manner
than the next Forward Programming device. The receiver must
be powered on and connected to be able to enter the forward
programming menu.
Forward Programming
To Next Page
Loading...
Need help?
General
