IM-S51-07 CTLS Issue 1
4
SP7-10, SP7-11, SP7-12 and SP7-20, SP7-21, SP7-22 Parameterization
1. General information
1.1 General information and instructions
These instructions are an important part of the product and must be retained for future reference. Installation, commissioning, and
maintenance of the product may only be performed by trained specialist personnel who have been authorized by the plant operator
accordingly. The specialist personnel must have read and understood the manual and must comply with its instructions. For additional
information or if specific problems occur that are not discussed in these instructions, contact the manufacturer. The content of these
instructions is neither part of nor an amendment to any previous or existing agreement, promise or legal relationship. Modifications and
repairs to the product may only be performed if expressly permitted by these instructions. Information and symbols on the product must
be observed. These may not be removed and must be fully legible at all times. The operating company must strictly observe the applicable
national regulations relating to the installation, function testing, repair and maintenance of electrical products.
1.2 Warnings
The warnings in these instructions are structured as follows:
DANGER
The signal word "DANGER" indicates an imminent danger.
Failure to observe this information will result in death or severe injury
WARNING
The signal word "WARNING" indicates an imminent danger. Failure to observe this information may result in
death or severe injury.
CAUTION
The signal word "CAUTION" indicates an imminent danger. Failure to observe this information may result in
minor or moderate injury.
NOTE
The signal word "NOTE" indicates useful or important information about the product.
The signal word "NOTE" is not a signal word indicating a danger to personnel The signal word "NOTE" can
also refer to material damage.
To Next Page
Loading...
