PXS-710D Section 5
69
TABLE 5.2
DISPLAYED FAULT CONDITIONS
DISPLAY FAULT DESCRIPTION ACTION REQUIRED
1 Inverter Fault. Reset Unit (1), Call for Service
2 No or low mA signal during exposure Call for Service
3 Exposure terminated by operator Reset unit
4 Stuck or shorted exposure switch. Check or replace switch.
5 Reserved
6 Reserved
7 Reserved
8 Exposure watchdog failure Call for Service
9 Flash CRC Error Call for Service
10 RAM Memory Error Call for Service
11 EEPROM CRC Error Call for Service
12 EEPROM Write Error Call for Service
13 Serial Communications Error Reset unit
14 Stuck or Shorted Prep Switch Check or replace switch.
LIMITED WARRANTY
Source-Ray, Inc.
warrants its Model PXS-710D Podiatry X-Ray Source to be free of
manufacturing defects, which can impair their normal operation when used within their
specified ratings. Claims under this warranty must be made within 3 years after shipment from
the factory. Such warranty shall not apply to defects resulting from accidents, alterations,
abuse or misuse. X-Ray Tube and Collimator warranty is limited to that provided by the
manufacture (one year). Liability under this warranty is limited to repair or replacement of
defective components at the factory.
Shipping costs are not included.
This warranty is in
lieu of any other warranty expressed or implied. Collimator LEDS, exposure cord assemblies,
interconnect cables are considered normal wear and tear and are not covered under this
limited warranty.
To Next Page
Loading...