January, 2016 120-1
Model F120 UV/IR Flame Detector
MODEL F120 UV/IR
Triple-Mode Flame Detector
SAFETY INFORMATION
Please read and understand this Design Manual BEFORE installing, operating, or conducting
maintenance on the ame detector.
Pay close attention to important messages marked as WARNINGS and IMPORTANT
throughout the Design Manual.
Failure to follow the instructions and safety precautions in this Design Manual can result in
serious injury or death.
Equipment that has been repaired or modied by the user, damaged as a result of an accident,
improper installation or used in an environment for which it was not intended will void the
warranty.
INSTALLATION WARNINGS
Installation of the detector must only be conducted by trained and in some cases a licensed
personnel.
Observe the recognized standards of the appropriate authority in the in the country concerned.
Follow all appropriate standards to maintain the overall certication of the detector. Ensure
all local regulations and site safety procedures are followed.
Declassify the area or disconnect the equipment from the power supply before accessing the
interior of the detector. Ensure that the cover for the housing is closed tight during operation.
DO NOT open the housing/enclosure or replace the electronic module in potentially hazardous
atmospheres while the POWER is still applied to the electronics module.
DO NOT tamper, modify, repair, or disassemble the electronics module or the detector.
DO NOT expose the detector to temperatures outside the recommended ranges or damage
or failure may occur.
Every effort has been made to ensure the accuracy of this Design Manual. However, Safety
Systems Technology assumes no responsibility for any errors or omissions in this document.
Please report any errors or omissions found in the content of the Design Manual.
Safety Systems Technology reserve the right to change or revise this Design Manual without
notice and without obligation to notify any person or organization of such changes. You may
request any additional information required that is not included in the Design Manual through
the local distributor or Safety Systems Technology.
To Next Page
Loading...