St George DEO2B - Mode Switch

CONTROL PANEL
OPERATION
3. CONTROL PANEL OPERATION
3.1
One Handed Operation
The oven timer control
has been designed so that
it requires only one hand
to operate any of it's various
functions.
To alter any of the functions
or settings you
need only to press the
relevant button/s. The selected
function will
remain
active for a few moments
allowing you to adjust
the setting. The v
or A buttons can be pressed
to adjust
the displayed time.
When the v or
A buttons are pressed singularly
the time will change
in 1 minute steps. If the v
or A buttons are
held down the time
will change more rapidly.
When you
are finished the selection
will be set and the display
will revert to the time
of day.
NOTE: The AUTO symbol
may flash and/or
the Ja symbol may be
displayed if those functions
have been inadvertently
set. To
cancel any AUTO settings
press the Reset button.
To cancel the timer function,
press the Timer
button and
set the alarm time back
to zero. If an alarm sounds,
pressing any of the
4 left hand buttons will cancel
it.
3.2 Setting the Time
of Day
The
time of day can be set
at any time by pressing
the Reset button. Once
pressed the time can
then be set by
pressing
the v or A buttons.
The unit will then commence
timing from the selected
time on the display.
NOTE: If the unit
is in automatic mode, resetting
the time of day
will cancel any automatic
settings.
3.3
Manual Operation
Pressing
the Reset button
at any time after turning
power on (see 2.1 above)
will cancel any automatic
setting in
memory and allow
the unit to be used manually.
The 8 indicator will
be displayed to show manual
operation has
been set.
3.4
Changing the Alarm Tone
The
alarm tone can be changed
to either one of
3 selections. Simply
press the v button singularly
to cycle
through the available
selections.
NOTE: This only works
if no other function is
active when the v button
is pressed.
8