St George DEO2B - Self Clean Oven Liners; Changing the Light Globe

CLEANING
AND
MAINTENANCE
5.6
Self Clean
Oven Liners
An
Optional Self
Clean Oven
Liner Kit
is available
as an accessory
which,
when fitted
into the oven,
catalyses
cooking
fats which
come into
contact
with their surfaces
during
oven operation.
The
fats bum and
flake to
the
oven
floor so a
quick brush
out when
the oven is
cool is all
that's required.
The non-liner
surfaces
in the
oven can
then be
wiped down
for brilliantly
simple
results.
For extra cleaning
action,
heat the
empty oven
at 230
0
C
for 15
to
20 minutes.
Be very careful
not to
scratch the
surfaces
of the liners.
Large spills
should
be removed
by sponging
the liners
using
warm water
and a soft
sponge. If
large areas
of the catalytic
coated liners
are covered
with cooking
fats
the
self
cleaning
action may
not be as
effective. The
catalytic
liners can
be cleaned
by removing
them from
the oven
and rinsing
with clear
hot water
only. Cleansing
agents
or oven cleaners
must
never be used
on the
self-clean
liners.
5.7 Changing
the
Light Globe
The
oven illumination
lamp/s
are located
in the
side wall/s
of the oven
compartment/s.
The
light globe
is located
behind
the glass
cover
and is a screw-in
type.
Ensure
that the appliance
is
switched off
before replacing
the
lamp to avoid
the possibility
of electric
shock.
To change
a light globe:-
1., Gently
lever out
the glass cover
from the
rear edge.
2. Unscrew
the light
globe and
screw in a
replacement
globe.
3. Replace
the glass
cover making
sure
it fits correctly
into place.
39