St George DEO2B - ELECTRICAL CONNECTION INSTRUCTIONS; Wiring Rules and Warnings; Electrical Loads

ELECTRICAL
CONNECTION INSTRUCTIONS
7. ELECTRICAL CONNECTION
INSTRUCTIONS
7.1 Wiring Rules
and Warnings
WARNING: All aspects of the installation
must conform with the requirements of the Standards
Australia (within
Australia) Wiring Rules
as well as your local electrical and building
codes and regulations and any
other applicable requirements and conditions
of your Local Power Supply Authority.
A licensed electrician must perform the
electrical work when installing this appliance.
The supply
cable and
fuse rating must be suitable for
the appliance.
WARNING: To
avoid mains borne interference, this appliance must
be installed individually on a separate and distinct
final sub-circuit.
NOTE: To the Electrician
- please ensure sufficient supply cable is provided
to allow the appliance to be removed from
the cavity should any servicing be necessary. This
will also allow easy connection of the supply.
7.2 Electrical Loads
MAIN OVEN UEO
DEO UES
Oven (Max.)
3800 W 3800 W 4200W
Grill
2700 W 2700 W
3500W
Oven Fan and Light
100W 100 W
100W
SECONDARY OVEN
Oven -2400
W-
Grill -2700
W-
Oven Light
- 30 W-
Total Rating
3.9 kW 6.63 kW 4.3
kW
When connected
to a subcircuit protected by a circuit breaker,
the current drawn by an oven may cause
the
circuit breaker to trip in some cases.
It is recommended that the following installation
procedures are used.
50