St George DEO2B - 2 Using the Appliance for the First Time; Power on; Burning in

USING THE
APPLIANCE
FOR
THE
FIRST TIME
2.
USING THE
APPLIANCE
FOR
THE FIRST
TIME
After installation
remove
all notification
labels
(not grill
or electrical
warning
labels),
advertising,
tape, packaging,
etc. A
quick diluted
wash
with Ammonia
and water
should
rinse away
any adhesive
residue.
Eucalyptus
oil (small
amounts)
is also
good
for removing
adhesive
residue.
Thoroughly
rinse
cleaned
surfaces
and wipe
them dry
using
a clean,
soft cloth.
NOTE: People
with
sensitivity
to cleaning
chemicals
must take
the necessary
precautions.
St George
recommends
wearing
protective
gloves
while
cleaning
the appliance.
2.1
Power
On
The
time of day
is displayed
in digital
24-hour
format
(e.g. 18:00
is 6:00
p.m.). When
power
is first
applied the
time
of
day (0:00)
and AUTO
flashes
in the
display.
Pressing
the Reset
button
cancels
power-up
mode
and automatically
places
the unit
in manual
mode.
2.2
Burning
In
Before
cooking
in the
appliance
an initial
pre-heat
is required
to burn
off the
fine oil
film used
to protect
the
elements
during
shipping.
The first
time you
heat up
the oven
(or grill)
the oil will
be given
off as
smoke
(some
smell may
also be
noticeable),
which
is perfectly
normal.
1. Set the
oven
for manual
operation
by pressing
the
Reset
button.
2. Select
Fan
Oven on
the mode
switch
and set
the main
oven temperature
to 18000.
3. With
the oven
door closed,
leave
the oven
on for
approximately
1 hour or
until the
smoke has
disappeared.
4.
Change
the selection
on
the mode
switch
to Fan Grill
and leave
for a further
20
minutes
or until the
smoke
has
disappeared.
5.
For the
DEO models,
with
the
secondary
oven
door open,
set the
grill control
to
it's maximum
setting
and
leave on
for at least
20 minutes
or
until the
smoke
has disappeared.
After
completing
the
above turn
the oven/s
off. The
oven/s
are now
ready for
cooking
and grilling.
NOTE:
The
secondary
oven (DEO
models)
may be
burned
in at the
same time
as the main
oven.
7