1. Install the ST700 Dash Display System and connect it to
the switched battery circuit, for example the ignition (B+)
and the battery negative (B–).
2. Install and connect the controls (following the instruc-
tions that start on page 13).
3. Connect the ST700 Dash Display System ‘ES’ wire to the
ignition low tension circuit.
4. Connect the sensors supplied with your system.
5. Turn on the ignition.
6. Use the Demonstration Mode to check that the ST700
Dash Display System is functioning normally.
7. Take the ST700 Dash Display System out of its demon-
stration mode by changing the setting for the number of
cylinders. See page 53 for instructions.
8. Use the Driver button to select the display layers
described on page 32.
9. Use the Rotary control to select the Memory Review and
Setup modes as described on page 44.
10.Use the rotary control to set up the ST700 Dash Display
System.
Q
u
i
c
k
S
t
a
r
t
To Next Page
Loading...