ST700 Dash Display SystemMemory and Setup
© Stack
59
turn the control to adjust the contrast setting in the range 0 to 31.
Settings at either extreme of this range will be difficult to see. Exper-
iment with the control to find the ideal setting.
❑ Lap timing layer—Press the rotary control briefly when the display
shows ‘Lap Time’ to see whether the lap timing layer is currently
enabled or disabled. Press and turn the control to change the set-
ting.
❑ Corner speed layer—Press the rotary control briefly when the dis-
play shows ‘Corner Spds’ to see whether the corner speed layer is
currently enabled or disabled. Press and turn the control to change
the setting.
Turn the rotary control clockwise and then press it to return the display
to show ‘Display Settings’. Turn the rotary control clockwise and press
it again to show ‘Exit Menus push button’. Press the control again to exit
the setup mode and to restore normal operation.
To Next Page
Loading...