ST700 Dash Display System Maintenance
© Stack
71
❑ ST700 Dash Display System wiring is too close to the HT leads and/
or injector leads, or the HT leads are tied to isolated metal work to
which the system wiring is also tied.
Run wiring away from HT leads and injector leads
Recommended minimum spacing is 75mm (3.0 inches)
Needle dances up and down, lap times appear and speed is shown
when the vehicle is stationary.
❑ The ST700 Dash Display System is in Demonstration Mode.
Set the correct number of cylinders, by following the instructions on
page 53, to turn off Demonstration Mode.
You can restore the ST700 Dash Display System to its factory settings
by pressing the Driver button and the Rotary control together, and
then switching on the ignition. This also clears the lap and split tim-
ings, and resets all the peak readings.
After you restore the factory settings, the Demonstration Mode will be
activated. To turn off the Demonstration Mode, set the correct number
of cylinders as instructed on page 53.
To Next Page
Loading...