STEMCELL TECHNOLOGIES INC.’S QUALITY MANAGEMENT SYSTEM IS CERTIFIED TO ISO 13485 MEDICAL DEVICE STANDARDS.
FOR RESEARCH USE ONLY. NOT INTENDED FOR HUMAN OR ANIMAL DIAGNOSTIC OR THERAPEUTIC USES.
TOLL-FREE PHONE 1 800 667 0322
PHONE +1 604 877 0713 VERSION 02
INFO@STEMCELL.COM
TECHSUPPORT@STEMCELL.COM
FOR GLOBAL CONTACT DETAILS VISIT WWW.STEMCELL.COM DOCUMENT #10000005578
21
Note: If the same protocol has been selected in more than one quadrant, RoboSep™-S will automatically
provide the option of sharing reagents across multiple quadrants. The quadrants that will utilize a single set of
reagents can be selected in the Resource Sharing screen. RoboSep™-S will indicate if a single reagent set
has insufficient volume to accommodate all of the specified quadrants.
Note: To remove a protocol from an assigned quadrant, select the quadrant number icon on the Run Samples
screen. An X will appear on the quadrant number icon (Figure 20). Select
[Delete] to remove the selected
protocol from the assigned quadrant. Any combination of quadrants can be selected in this manner.
Figure 20. Removing a Protocol from an Assigned Quadrant
4.3.2 Preparing the Cells
Refer to the Product Information Sheet (PIS) that came with your cell separation kit for instructions on how to
prepare cells for separation.
4.3.3 Loading the Carousel and Starting a Run
RoboSep™-S comes with a RoboSep™ Service Rack to hold and organize reagents and sample tubes prior
to loading them onto the carousel (Figure 21). The rack can also be used to hold the tube caps during the
separation protocol. Place the caps upside down in the rack’s designated spots.
Figure 21. RoboSep™ Service Rack. Tubes and vials placed in the rack before loading the carousel.
Quadrant numbers are noted on the side of the rack.
To Next Page
Loading...