STEMCELL TECHNOLOGIES INC.’S QUALITY MANAGEMENT SYSTEM IS CERTIFIED TO ISO 13485 MEDICAL DEVICE STANDARDS.
FOR RESEARCH USE ONLY. NOT INTENDED FOR HUMAN OR ANIMAL DIAGNOSTIC OR THERAPEUTIC USES.
TOLL-FREE PHONE 1 800 667 0322
PHONE +1 604 877 0713 VERSION 02
INFO@STEMCELL.COM
TECHSUPPORT@STEMCELL.COM
FOR GLOBAL CONTACT DETAILS VISIT WWW.STEMCELL.COM DOCUMENT #10000005578
30
7.0 Specifications
Capacity
Labels and separates up to 4 samples simultaneously
Sample volume: from 0.25 - 8.5 mL for each sample
Dimensions (with lid)
42 cm W x 42 cm D x 52.2 cm H
16.5” W x 16.5” D x 20.5” H
Weight
22 kg (48.5 lb) dry weight (without magnets)
58 kg (123 lb) shipping weight
Power Requirements
100 - 240 V~, 50/60 Hz, 65W
2 x fuses: FB 4 A 250 V~
Optimal Operating Conditions
15 - 30°C
20 - 85% relative humidity (non-condensing)
Not specified for use inside an incubator or cold room
Does not require placement in a biohazard safety cabinet
Indoor use only
Storage and Shipping Conditions
-30°C to 50°C
10 - 90% relative humidity
Applied Standards
Certified to CAN/CSA STD 22.2 No. 61010-1-12
Conforms to UL STD 61010-1:2012
Conforms to IEC STD 61326-1:2012 / EN STD 61326-1:2013
FCC Part 15 Subpart B: 2014
ICES-003:2014
Meets all the Provisions of the Indicated
European Directives
2014/35/EU (Low Voltage Directive) and 2014/30/EU (EMC Directive)
RoboSep™-S is designed and manufactured so that it does not endanger the safety of operators when
properly installed, maintained and used in applications for which it was intended. RoboSep™-S meets the
requirements of European Directives 2014/35/EU and 2014/30/EU. RoboSep™-S meets the requirements of
CAN/CSA-C22.2 No. 61010-1-12 and UL standard No. 61010-1:2012 (safety requirements for electrical
equipment for measurement, control, and laboratory use).
The RoboSep™-S unit has the following symbol affixed to the rear:
This waste electrical and electronic equipment (WEEE) directive symbol denotes that the device should not
be disposed of in municipal waste collection centers. RoboSep™-S has been designed for easy dismantling
and recycling. Contact STEMCELL Technologies regarding end-of-life care for RoboSep™-S.
For more information on RoboSep™-S warranties, refer to www.stemcell.com or contact us at
techsupport@stemcell.com.
To Next Page
Loading...