Stihl GS 461 - Page 45

44 GS 461
: Pull fuel suction hose (1) out of
the guide (arrow) and set it aside
: Press out bushing (1) in the
direction of the carburetor space
and pull out wiring harness (2) in
the direction of the carburetor
space
– Remove switch shaft, b 9.1.1
3443RA210 TG
1
3443RA211 TG
1
2
: Pull off blade receptacle (1) and
pull wiring harness out of the
guides (arrows)
– Check contact spring and switch
housing, replace if necessary,
b 6.6.4
– Examine wiring harness, replace
if necessary
Installation
: Push wiring harness (1) with
protective tube (2) in front
through the hole (arrow) towards
the cylinder
2411RA060 TG
1
3443RA216 TG
12
– Use STIHL press fluid to simplify
assembly, b 12
: Press the bushing (1) into the
hole so that the wires run
horizontally in the bushing
The bushing (1) must enclose the
hole completely on the opposite
side.
: Push wiring harness as far as it
will go into the protective tube (2)
towards the bushing
3443RA217 TG
1
3443RA218 TG
1
2