Stihl MS 500i - Disassembling Clutch; Assembling Clutch; Installing Clutch

MS 500i16
If wall thickness a is less than 80% of wall thickness b:
N Replace clutch drum (4).
11.4 Disassembling clutch
N Remove the clutch, @ 11.2.
N Use hook 5910 890 2800 to remove the clutch springs
(10).
N Remove centrifugal weights (8) from carrier (11).
N Remove the holder (9) from the carrier (11).
11.5 Assembling clutch
N Slide the holder (9) onto the centrifugal weights (8).
N Slide the centrifugal weights (8) together with the
holder (9) onto the carrier (11).
N Hook clutch springs (10) onto the side with the
hexagon (arrow) using the hook 5910 890 2800.
11.6 Installing clutch
N Assembling clutch, @ 11.5.
N Slide washer (7) onto the crankshaft (8) so that the
marking “TOP” is visible.
N Slide locking strip 0000 893 5904 through the spark
plug hole and hold.
N Turn clutch (6) as far as possible anticlockwise by
hand on the crankshaft.
The piston is blocked.
N Tighten clutch (6) counterclockwise.
N Pull locking strip 0000 893 5904 out of the spark plug
hole.
N Install the spark plug.
N Position the spark plug boot (2) so that the tab (arrow)
is located in the recesses of the air guide shroud.
N Install shroud.
N Slide on the needle cage (5).
N Slide on the clutch drum (4) so that the spigot (arrow)
of the worm sits in the groove (arrow) of the clutch
drum (4).
N Slide on rim sprocket (3).
N Slide on the washer (2).
N Install the circlip (1).
N Attach the chain sprocket cover.
N Engage chain brake.
N Calibrate the chain saw, @ 4.
The control unit is optimally adjusted to the mechanical
and mechatronic components.
10
0000-GXX-3542-A0
9
8
11
0000-GXX-3543
10
0000-GXX-3506-A0
0000-GXX-5610-A0
4
0000-GXX-5588-A0