Stihl MS 500i

MS 500i58
28.1 Tools, Servicing Aids
– Screwdriver – 0000 890 2300 or equivalent
– Jaws (No. 3.1 + 4) – 0000 893 3706
– Jaws (No. 6) – 0000 893 3711
– Snap ring pliers, DIN5254-A10 – 0811 611 8200 or
equivalent
– Socket, T27x125 – 0812 542 2104 or equivalent
– Press sleeve – 1113 893 4600
– Press sleeve – 1141 893 2400
– Installing sleeve – 1141 893 4600
– Press sleeve – 1143 893 2400
– Press sleeve – 4119 893 2400
– Torque wrench – 5910 890 0302 or equivalent
– Service tool AS – 5910 890 2222
– Screwdriver, Q-4x150 – 5910 890 2405
– Screwdriver, T27x200 – 5910 890 2415 or equivalent
– Puller – 5910 890 4400
– Puller – 5910 890 4505
– Guide – 5910 895 0901
– Socket, DIN3124, 13mm – 5910 893 5608 or
equivalent
– Socket, 17 mm – 5910 893 5610 or equivalent
– Socket, DIN3124-S19x12.5L – 5910 893 5613 or
equivalent
– Hot air blower
– 2 M8 nuts
– Pin punch, 3 mm
– STIHL multipurpose grease – 0781 120 1110
– Solvent-based degreasant containing no chlorinated
or halogenated hydrocarbons
28.2 Removing Oil Seals
N Preparations, @ 3.1.
N Remove the shroud.
N Remove the spark plug.
N Remove the chain sprocket cover.
N Remove the clutch, @ 11.2.
N Remove the worm, @ 14.4.
N Remove the oil pump, @ 14.5.
N Remove the E-clip (9).
N Remove the rewind starter, @ 10.2.
N Remove the flywheel, @ 18.2.
N Remove the generator and put it to one side, @ 22.2.
The generator’s wiring harness need not be removed.
28 Crankcase, Crankshaft, Oil Seals
1
2
3
4
5
6
8
9
7
10
11 M5x27
(3 Nm /
27 lbf. in.)
1
2
+
90°
3 Nm /
27 lbf. in.
0000-GXX-5651-A0